- 145: Site_visit, Site 6, Wed 22-Oct-2003 09:09:11 EDT, st6: Corn Field Cut
10/21/03 16:00 - 17:10
Corn Field Cut on 10/20/03
Photos taken.
SDR/metppf uploaded
Barometer removed: This turkey was still misbehaiving despite
new 485 chip.
CFG/syslog uploaded
- 126: Site_visit, Site 6, Fri 17-Oct-2003 08:17:46 EDT, st6: CO2 Added, Baro Installed, Antenna moved, routine
10/16/03 14:00-15:40
CO2 Sensor #76 Installed.
Baro S610002 installed:
This was the sensor removed previously from this station because
it was misbehaiving on the sbus. We'll try it again now that it
has the new RS485 chip installed. In the lab it seemed to work ok.
GOES Antenna moved 14:35
to post just south of the west leg, hopefully to
reduce noise on microBaro/T.
Krypton cleaned:
before ~380mV, after ~720mV
Rad. cleaned
IRT cleaned: had very small cobweb across view port
Time: updated. it had been about 2-sec. slow
Soil sample taken.
RG OK
SDR/Metppf data uploaded
- 110: Site_visit, Site 6, Thu 09-Oct-2003 13:49:01 EDT, Site 6 visit, Oct 9
Site 6 visit, Oct 9, Kyle & Steve
Arrived 1040 EDT
Removed baro to put at station 1(ser#U4110004)
Changed from format 163 to 162
1057 leaving
- 104: Site_visit, Site 6, Tue 07-Oct-2003 17:00:24 EDT, Site 6 visit, Oct 7
Site 6 visit, Oct 7, SPO & KDH
Arrived approx. 1310 EDT
Disconnected solar panels and 2 batteries to simulate low voltage at night.
1329 Vbatt - 12.7V, Poll debug errors start.
Replaced MAX487 on serial daughter.
Now working Vbatt - 12.6, then not working.
LTC4911N inside Baro.
Baro on SBUS not working so switching back to no SBUS. Working.
- 100: Site_visit, Site 6, Mon 06-Oct-2003 16:45:35 EDT, Site 6 visit, Oct 6
Site 1 visit, Oct 6, SPO, KDH, & Sakai
Arrived 1345 EDT
copy metppf
clean rads
Changed baro to SBUS
Changed CO/6 to GPS(prep for RMT, if it comes)
Sakai added PP
1408 forgot to copy config to config.dat-reboot again, PP connected-1.78V
1352 TRIME: 30.9, 22.8, 36.7%
core taken
- 84: Site_visit, Site 6, Wed 01-Oct-2003 11:13:48 EDT, Site 6 visit, Sept 30
Site 6 visit, Sept 30, SPO & KDH
Arrived 1346 EDT
Cleaned krypton 380mV->540
Mast down 1359->1405
Grabbed SDR
Copied metppf
1355:Trime 38.3; 38.2; 36.0%
1355: soil core sample taken
Cleaned rad
1346 Rain gauge calibration started 79-190, some light rain but still continuing with rain cal.
Garmin 42deg 10.846' 73deg 53.681' 25m(16')
Some wet spots, mostly like previous visit, park at top of road next time, getting too muddy.
1442 left site
- 69: Site_visit, Site 6, Thu 25-Sep-2003 17:03:23 EDT, Site 6 visit, Sept 25
Site 6 visit, Sept 25, SPO and Tom
Arrived 1042 EDT, road muddy so walked to site, left at 1130 EDT
SPO replaced Rnet: pulled (plug) 1041 EDT s/n Q94196, coef = {9.21/11.54}
installed s/n Q97034, coef = {9.21/11.37}
changed Rnet coefficients in logger
old Rnet had moisture inside both top and bottom domes
downloaded metppf data and swapped fastout media
Soil sample at 1122 EDT w/worm (SPO)
Trime = 31.8% no pilot tool
30.3% no pilot tool
30.2% no pilot tool
Did not lower mast and clean kh2o
GARMIN: N 42 deg 10.848'; W 73 deg 53.681'; elevation = 24 m
- 58: Site_visit, Site 6, Mon 22-Sep-2003 18:02:41 EDT, Site 6 visit, Sept 22
Site 6 visit, September 22, Kurt and Tom
arrived 1250 EDT, left 1405 EDT
Found rain gauge tipped at 45 degree angle; Kurt repaired
Mast lowered at 1714 GMT; raised 1722
kh2o output = 240 mV; cleaned; output = 291 mV
Qsoil = 37.38% at 1726 GMT
Soil sample collected at 1727
Trime = 28.2% with pilot tool
21.2% with pilot tool (slightly steeper angle)
25.8% with pilot tool
Cleaned radiometers at 1741 GMT; Rnet top dome is scratched or split
Took fetch photographs
Downloaded local data storage and swapped fastout
Downloaded new KRY1392s.DAT to EVE and /card
- 37: Site_visit, Site 6, Mon 15-Sep-2003 14:49:04 EDT, Site 6 visit, Sept 13
Visited site 6, Sept 13; Kurt and Tom
Lowered mast 1400 EDT
Raised mast 1410 EDT
KH2O output = 63 mV; cleaned; output = 152 mV
Downloaded SDR fastout; also thought I downloaded local data
storage, but could not find it later back at the base!
RMY BoomDirection = 358 deg
Reset PAM clock
- 20: Loggers, Site 6, Mon 11-Aug-2003 14:54:08 MDT, Site 6 CR10X calibration file
Q94196-A+ NET 00 9.21
A- x 01 11.54
x PygIn 02 0.0
x PygOut 03 0.0
x PspIn 04 0.0
x Psput 05 0.0
H993563 HFT 06 38.9
PY7121 SlDn 07 -127.6
Tcin-A0 x 10 0.0
A1 x 11 0.0
A2 x 12 0.0
A3 x 13 0.0
A4 x 14 0.0
Tdin-A0 x 15 0.0
A1 x 16 0.0
A2 x 17 0.0
A3 x 18 0.0
A4 x 19 0.0
Tcot-A0 x 20 0.0
A1 x 21 0.0
A2 x 22 0.0
A3 x 23 0.0
A4 x 24 0.0
Tdot-A0 x 25 0.0
A1 x 26 0.0
A2 x 27 0.0
A3 x 28 0.0
A4 x 29 0.0
STP99242-A0 Tsoil 30 -253.598632
A1 x 31 252.4421807
A2 x 32 0.5895518
x-A0 LevelX 33 0.0
A1 x 34 0.0
A2 x 35 0.0
A3 x 36 0.0
A4 x 37 0.0
A5 x 38 0.0
x-A0 LevelY 39 0.0
A1 x 40 0.0
A2 x 41 0.0
A3 x 42 0.0
A4 x 43 0.0
A5 x 44 0.0
006-A0 CS615 45 -.187
A1 x 46 .037
A2 x 47 .335
TP01 timeout 50 180
levels x 98 0
baud x 99 1