- 127: Site_visit, Site 9, Fri 17-Oct-2003 08:32:29 EDT, st9: CO2 Added, Antenna moved, routine
10/16/03 17:10-17:50
CO2 Sensor #78 Installed.
GOES Antenna moved 17:25
to post just south of the west leg, hopefully to
reduce noise on microBaro/T.
Krypton NOT cleaned: last visit was on 10/12 and it was reading ~950mV
Rad. cleaned
Soil sample NOT taken: soil was saturated from recent rain and water is
standing 5cm below surface.
RG OK
SDR/Metppf data uploaded
- 112: Barometer, Site 9, Sun 12-Oct-2003 16:09:15 EDT, st9: removed Baro
10/12/03 18:15-19:00 Z visit
Baro NCAR003 removed: This unit has been dead for a few days and
was dying on the sbus. Returned to base for
repair/exam.
SDR data uploaded.
Metppf data uploaded.
- 111: Site_visit, Site 9, Thu 09-Oct-2003 13:51:52 EDT, Site 9 visit, Oct 9
Site 9 visit, Oct 9, Kyle & Steve
Arrived 1150 EDT
1153 collected soil sample
TRIME 34.7, 37.5, 38.3%
Baro not working as of 0600
Baro on SBUS
Unplugged and plugged back in and is working
Swapped internal SBUS cable and is now not working
Unplugged and plugged back in and is now working
Grabbed SDR
Copied metppf
1219 leaving
- 97: Site_visit, Site 9, Sun 05-Oct-2003 15:32:01 EDT, Site 9 visit, Oct 5
Site 9 visit, Oct 5, SPO & KDH
Arrived approx. 1400 EDT
Swapped Baro from St1. Running with SBUS.
Nylocks on Baro only finger tight.
Standing water around sight. Looking drier.
1418 leaving, everything working great.
- 92: Site_visit, Site 9, Sat 04-Oct-2003 10:39:39 EDT, Site 9 visit, Oct 3
Site 9 visit, Oct 3, SPO, KDH, & Sakai
Arrived 1152 EDT
Swapped TRH 702 -> 204
Grabbed SDR and metppf -> .274
1207 TRIME 35.8, 33.7, 33.6%
Disconnected O3.
Replaced teflon tubing with tygon tubing
1222 left
- 91: Site_visit, Site 9, Fri 03-Oct-2003 09:59:27 EDT, Site 9 visit, Oct 2
Site 9 visit, Oct 2, SPO, KDH, & Sakai
Arrived 1404 EDT
Arrived format was 161. Changed to format 162.
No SBus cable inside box. Baro says "No SBus". fmt0162 requires it, since CO2 needs it. Seems to work:)
1438: Done adding uBaro & Ozone. Iload now approx. 1.1A.
1438: left site with light rain.
- 83: Site_visit, Site 9, Wed 01-Oct-2003 10:54:34 EDT, Site 9 visit, Sept 30
Site 9 visit, Sept 30, SPO & KDH
Arrived 1031 EDT
Cleaned krypton 240mV->860
Mast down 1159->1205
Grabbed SDR - RAMDISK /card not found. Reboot - no data since 270
Copied metppf
1151:Trime 39.5; 39.0; 38.3%
1151: soil core sample taken
Cleaned rad
1031 Rain gauge calibration started 316-333, stopped for reboot, 1156 rain
restarted - 0 tips, 1240 another 91 tips on rain, 118 total
Garmin 42deg 27.763' 73deg 44.660' 76m(20ft)
loaded s09_0162.dat
Went back to s06-0160.dat since pressure not working
1245 left site
- 74: Site_visit, Site 9, Sat 27-Sep-2003 15:14:50 EDT, Site 9 visit, Sept 27
Site 9 visit, Sept 27, SPO
Arrived 1120 EDT; rain just started in region -- light to moderate during
entire visit. Heard rain gauge tip. Since wet:
- didn't clean krypton
- didn't clean rads
- didn't grab metppf (didn't want to use laptop in rain or keep box open)
(forgot to do GARMIN)
1125 Trime: 43.4; 36.1; 34.5%
1125 Removed soil core
1140 Grabbed SDR (quickly!)
- 44: Slow_AD_Tsfc, Site 9, Tue 16-Sep-2003 08:00:41 EDT, site 9 visit, Sept 15
site #9 visit 9/15/03
AD not working for channel 5 (Tsfc) - reseated boards, now unit works OK
checked all serial numbers, and boom direction, (355), OK with entry #26
cleaned KH2O, mast down at 21:13 GMT, up at 21:19. Signal increased from 37.4 mv to 176.7 mv
downloaded fast and slow data
cleaned radiometer, took dirt sample 21:28 GMT 3-6 cm depth
fast data SDR hung for 1 1/4 hr, cycled power, now OK
- 35: Site_visit, Site 9, Sun 14-Sep-2003 09:36:02 EDT, Site 9 visit, Sept 12
Station visit, site 9, Sept 12, Kurt, Kyle, and Tom
Kyle's field notes follow:
Lowered mast 20:45 GMT
Raised mast 21:20 GMT
Cleaned KH2O: before 9 mV, after 840 mV
Serial numbers of sensors:
Krypton: 1395
Licor PY: 9024
Net rad: 90076
RMY: 38769 (boom direction 355 deg)
TP01: 200235
Tsoil: STP 97003
QSoil: 009
HFT: 87034
Kurt added logger fix for CS615
- 27: Sonics, Site 9, Fri 12-Sep-2003 14:46:14 EDT, Csat has 'thread' on transducers
Site 9 has a fine cotton thread strand crossing over the up-looking transducers
that SteveO used during testing in Boulder.
This may help improve the csat recovery time in rain if the water is wicked away.
- 23: Loggers, Site 9, Mon 11-Aug-2003 14:54:44 MDT, Site 9 CR10X calibration file
Q90076-A+ NET 00 9
A- x 01 11.18
x PygIn 02 0.0
x PygOut 03 0.0
x PspIn 04 0.0
x Psput 05 0.0
H87034 HFT 06 36.8
PY9024 SlDn 07 -110.3
Tcin-A0 x 10 0.0
A1 x 11 0.0
A2 x 12 0.0
A3 x 13 0.0
A4 x 14 0.0
Tdin-A0 x 15 0.0
A1 x 16 0.0
A2 x 17 0.0
A3 x 18 0.0
A4 x 19 0.0
Tcot-A0 x 20 0.0
A1 x 21 0.0
A2 x 22 0.0
A3 x 23 0.0
A4 x 24 0.0
Tdot-A0 x 25 0.0
A1 x 26 0.0
A2 x 27 0.0
A3 x 28 0.0
A4 x 29 0.0
STP97003-A0 Tsoil 30 -237.31102
A1 x 31 223.69219
A2 x 32 13.51843
x-A0 LevelX 33 0.0
A1 x 34 0.0
A2 x 35 0.0
A3 x 36 0.0
A4 x 37 0.0
A5 x 38 0.0
x-A0 LevelY 39 0.0
A1 x 40 0.0
A2 x 41 0.0
A3 x 42 0.0
A4 x 43 0.0
A5 x 44 0.0
009-A0 CS615 45 -.187
A1 x 46 .037
A2 x 47 .335
TP01 timeout 50 180
levels x 98 0
baud x 99 1