Operational Status:
still under development and not requestable
General Description:
- The CR-2 hygrometer determines the frost point of the air in its internal chamber by cooling a mirror until front appears on the mirror and then maintaining the mirror at the threshold temperature for such frost to be present. A Stirling-cycle cryocooler is used so no cryogen escapes to the atmosphere. Optical sensors detect the presence of frost on the mirror, as illustrated in the diagrams below, and a platinum RTD sensor in thermal contact with the mirror is used to measure the mirror temperature. Pressure is also measured in the sensing chamber so the frost point can be converted to other measures of humidity like mixing ratio. This is essential to obtaining useful measurements because lines from an inlet and to an exhaaust port are used to maintain flow through the instrument, so the pressure in the internal chamber usually differs from the ambient pressure at the flight level. When the measurements are used, the frost-point measurement in the chamber is converted to verious measures of humidity at the ambient pressure outside the aircraft. There is a Users' Manual (referenced in the Documentation section at the end of this page) that describes the instrument in some detail and provides the operating characteristics from which the following entries were derived.
Measurement Characteristics:
- Overall estimate of uncertainty: claimed 0.1K accuracy down to -100 C (unverified)
- Response time: dependent on conditions; 1-30 s
- Precision:
- Other measurement characteristics (comments on signal/noise, bias limits, etc):